I Downloaded from http://www.everyspec.com INCII-F OUND NIL-STO- 399(NAVY) SECTION 50A January 988 SUPERSEDING MIL-sTr)-399(NAvY) secr IoN 50 December 970 (See 8.) MILITARY STANDARD INTE8FACE STANDARD FOR SHIPBOARD SYSTEMS SECTION 50 NOMENCLATURE, ELECTRONIC AND WAPONS CONTROL FUNCTIONS AMSC N/A FSC 990 DISTRIBUTION STATENENT A Approved for public release; distribution unlimited
I MIL-STD-399(NAVY) SECTION 50A January 988 DEPARTMENT OF THE NAVY NAVAL SEA SYSTEMS COMMAND Washington, DC 036-50 Interface Standard for Shipboard Systems, Nomenclature, Electronic and t.jeaponscontrol Functions. This Military Standard is app.rove. d for use by the Naval Sea Systems Comma nd, Department of the Navy, and is available for use by all Departments and Agencies of the Department. of Defense. 7... Beneficial comments (recommendat ions, additions, deletions) and any pertinent data which mav be of use in im~rovin$? this document should be addressed to : Commander, Naval Sea Systems C&mand, SEA.55Z3,Department of the Navy, Washington, DC 036-50 by using the self-addressed Standardization Document Improvement Proposal (DD Form 46) appearing at the end of this doc,j- ment or by letter. ii
MIL-STD-399(NAVY) SECTION 50A January 988 The purpose of this section is to establish guidelines which will ensure the application of standard and uniform nomenclature of electronic and weapons control interface functions in order to facilitate installation planning and control and eliminate possible ambiguity at the shipboard installation interface. iii
MIL-STD- 399(NAVY) SECTION 50A January 988 CONTENTS Paragraph........ 3. 3. 3. 4. 5. 5. 5. 6. 6. 6. 7. 8. 8. 8. SCOPE... General... Scope... REFERENCED DOCUMENTS... Government documents... Standards... Oi-derof precedence... DEFINITIONS... Interface function... Inter face function term... REQU[RENENTS... Description AND APPLICATION.... Descript ion... Application... DEVIATIONS... Terms not available... Reporting procedure... REPORTS AND CORRESPONDENCE..... NOTES... Subject term (keyword) listing... Changes from previous issue... page I :0 iv
NIL-STD-399(NAVY) SECTION 50A January 988. SCOPE. policies Ceneral. This section is an integral part of UOI)-STD-399 and the and procedures established therein are mandatory.. scode. This section establishes the requirement for the use of standard and uniform nomenclature for electronic and weapons control interface functions flowing through systems and equipment component boundaries of Naval ship combat systems.. REFERENCED DOCUMENTS. Covernnent documents... Standards. Unless otherwise specified, tbe following standards of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation form a part of thi.a standard to the extent specified herein. STANDARDS MILITARY MIL-STD-343 - Glossary of Terms for Electronic and Neapons Control Interface Functions (Naval Ship Combat Systems ). DOD-STD-399 - Interface Standard for Shipboard Systems. (Metric) (Copies of standards required by contractors in connection with specific acquisition functions should be obtained from the contracting activity or as directed by the contracting officer. ). Order of precedence. In the event of a conflict between the text of this standard and the references cited herein, the text of this standard shall take precedence. 3. DEFINITIONS 3. Interface function. An interface function is a unit of functional information or pbyaica I action and relation which flows through an interface. It is a discrete electrical, electronic, or mechanical information identity or action identity that can be defined by ita characteristics or time relationship. 3. Interface function term. An interface function term is the precise and unique nomenclature applied to an interface in accordance with prescribed standards. 4. REQUIREMENTS 4. The nomenclature requirements established herein are mandatory (see requirements of DOD-STD-399).
MIL-STD- 399(NAVY) SECTION 50A January 988 5. DESCRIPTION AND APPLICATION 5. Description. Standard and uniform requirements for nomenclature 05 electronic and weapons ccilltrolinterface functions have been established by NIL-STD-343. It provides for the structuring of such terms in all foreseeable situations in connection with electronic and weapons control interface functions utilized in Naval ship combat systems. 5. Application. ~ L-sTD-343 shall be used to assign standard and uniform nomenclature for electronic and weapons control interface functons used in Naval ship combat systems wherever applicable. 6. DSVIATIONS 6. Terms not available. Although MIL-STD-343 provides for the structuring of electronic and weapons control interface function terms for any foreseen situation, it is still conceivable that technological advances affecting the design of future systems and equipments may require terms not available from NIL-STD- I343. In such instance, a report shall be submitted promptly which fully identifies the functions involved and completely describes the proposed use and the parameters (see 6.). NAVSEA will then provide the proper standard nomenclature to be used. NAVSEA will also incorporate the new terms in subsequent revision of MI L-STD-343. 6. Reporting procedure. Reports submitted in accordance with 6. shall be forwarded as indicated in 7.. 7. REPORTS AND CORRESPONDENCE 7. Reports, correspondence and similar information shall be submitted by the contracting activity to NAVSEA for action with copies to: to of 8. NOTES (a) NAVSEA 06D (b) Program manager 8. Subject term (key word) listing..,,,.,. Component boundary Iriterface functibn Ship combat system 8. Changes from previous issue. Asterisks are not used in this revision identify changes with respect to the previous issue due to the extensiveness the changes. Review activities : Preparing activity: OS, EC Navy - SH (Project 990-N064) User activity: YD e
INSTRUCTIONS. In continuing effoti to make our standardization documentsbetter, thedod provides tti formfor use in submitting comment# and suggestion for improvements. AN usen of military standardization documenb are invited to provide suggestions. hi! formmay he detached, folded along the lines indicated, taped along the loose edge (DO NOT STAPLEJ, and mailed. In block 5, be M specific an porwible about particular problem areas such m wording which required interpretation, wru tao rigid, restrictive, loose, ambiguous, or was incompatible, and give proposed wording changw which wou)d alleviate the problem. Enter in block 6 any remarks not related to a specific paragraph of the document. If block 7 is filled out, m acknowledgement till be mailed to you within 30 days to let you know that your commenti were received md are being cotidered. NOTE: his form may not be used to request copies of documents, nor to request waivern, deviations, or clarification of m=ifimtio~ ~quiremen~ on cu~nt contmc~. Commenb submitted on thb form do not constitute or imply authorization to waive any porthm of the referenced document(c) or to amend contractual requirements. (Fold cilo ~ thb.,) DEPARTMENT OF THE NAVY COMMANDER NAVAL SEA SYSTEMS COMMAND (SEA 553) DEPARTMENT OF THE NAVY.F[ WASHINGTON, DC 036-50 UNITED STATES OFFICIAL EUSINE33 PENALTY FOR PRIVATE use S300 BUSINESS REPLY MAIL FIRST CLASS PERMIT NO, 503 WASHINGTON D. C. P0TAGE wlll 6E paio,by THE DEPARTMENT OF THE NAVY COMMANDER NAVAL SEA SYSTEMS COMMAND (SEA 553) DEPARTMENT OF THE NAVY WASHINGTON, DC 036-50
STANDARDIZATION DOCUMENT IMPROVEMENT PROPOSAL (See Instructions - Reverze Side), GOCUMENTTITLE INTERFACE S ANJ)ARD F(JR SHIPBOARD SYSTEMS NOMENCLATURE. ELECTRONIC AND WEAPONS CONTROL FUNCTIONS. NAME OFSUBMl TTl NGOFt GANAT0N & TYPE OF ORGANIZATION (Md mu) vendor H USER AODREti(Skt. Citi, Skti, ZIP C&l MAN FAc, mer 0T4En (Sp,cvy}: _ PROBLEM AREAS a P.r.grooh N.rnt..r.nd Wordtnw REMARKS.. NAME OF SUB MI TTEFI act, Fint, MI) - oc,tl.mti b. WOIIKTELEPHONI! NuMBER(l.clM& Ch) - Ontlwul MA ILINGADDRESS (Sti,t. Cti, SaW. ZPC4)- 0Ptlond a 0A7E of SUBMI~ION (y VmMDDI DD LOR n 46 PREVIOUS EDITION lsopsolete,